Simpson DTC Roof Truss Clips

For alignment control between a roof truss and nonbearing walls; the 1 1/2″ slot permits vertical truss chord movement when loads are applied.

Material

• 18 gauge (43 mil)

Finish

• Galvanized (G90)

Installation

• Use all specified fasteners; see General Notes.
• Use STC or DTC depending on required loads.
• STC / STCT / DTC may be used with proprietary material sections. Contact material supplier for specific installation details.
• Use STCT where truss or rafter is separated from the top plate of the nonbearing wall.
• Install slot screws in the middle of the slot.